The shaping spray gun is not the most important part of the manufacturing machine, the intelligent control core is. There will be a miniature master brain in the control core, which is responsible for breaking down the blueprint into tasks that the manufacturing machine can complete, and controlling the completion of each component one by one. Although the micro main brain of the manufacturing machine does not focus on performance, but on safety and reliability, so it is often manufactured with technology that is two or three generations behind. However, it is still a main brain, and its complexity far exceeds the most advanced chips of the home star era. It is completely different. Belongs to the category of handmade.
It's hard to say that Chu Jungui was an advanced master brain, but he still remembered dozens of sets of design drawings and manufacturing processes for a backward master brain. If it had to be made by hand, his hand-made accuracy was barely up to standard. It's just that it is a huge project, and it cannot be completed in less than ten days. The best way to create a master brain is to use a manufacturing machine with advanced processes. But without a master brain, there is no manufacturing machine. This leads to an endless loop. This is also the reason why humans have been exploring real dreams for decades and have never entered the master brain era.
But now Chu Jungui has a way to break the situation: Kaitian.
Chu Jungui pulled out all the control lines of the prototype manufacturing machine and turned it into a data interface composed of hundreds of copper wires. It's a bit primitive and rough, but it works. It would take another day to create a modern standard biological data interface, but this copper wire only took Chu Jungui 3 minutes.
After powering on and connecting to Kaitian, the manufacturing machine finally started to move. Chu Jungui inserted the prepared material rod into the feed port. After a few minutes, the manufacturing machine began to spit out parts one by one.
Chu Jungui handed over all the mechanical parts of the shaping spray gun to Kaitian, and went to grind a few crystal cores himself. This manufacturing machine could not make them, so he had to polish them manually. Fortunately, the test subject's hands were like lightning, and he could grind out a surface in two strokes. A core with hundreds of facets was formed in his hands at a speed visible to the naked eye, faster than mechanical processing.
20 minutes later, the second manufacturing machine was completed, and Kaitian had another handful of copper wire in his hand. Then the two manufacturing machines started working at the same time. Kaitian automatically optimized the process and assigned different tasks to each. 10 minutes later, the third manufacturing machine was born. The next three units will start construction at the same time...
An hour later, ten manufacturing machines were lined up in front of Chu Jungui, neatly stacked. It's just that it's a bit difficult to open the sky. The thin body has to be stretched to more than ten meters in order to control all the manufacturing machines at the same time. But this is its limit.
Reality made Chu Jungui slightly change his plan. He first built a batch of data wires and interfaces, and then integrated all the interfaces onto a platform, so that Kaitian could finally be together again.
Chu Jungui placed a pot of dark food next to Kaitian, and then took out a cactus and gave it to him. Kaitian suddenly had a great appetite and became energetic. He started eating and working at the same time. To be honest, controlling the manufacturing machine is much easier than cutting wood. The main reason is that the taste of wood is really bad and there is not much heat to be chewed.
With a manufacturing machine, anything is possible. The first thing Chu Jungui built was the thermal energy conversion network. In the real dream, the fuel is close to infinite. As long as the number of thermal energy power furnaces is enough, the energy will be infinite. Chu Jungui has become accustomed to using energy to kill his opponents.
Chu Jungui built a three-meter-high, two-meter-diameter fixed power furnace out of stones. The inner wall was coated with river mud that would solidify when heated and had acceptable thermal insulation efficiency. A thermal energy conversion net was placed on the upper layer. This fixed power furnace is just a transitional one, with a single power of 200kw. Although it is a bit small, since it is going to be mass-produced, there will naturally be more than one. Chu Jungui plans to build five units in the first batch.
With a power of 1000kw, it can barely drive a slightly larger electric furnace.
So in the third hour, Chu Jungui had five thermal furnaces, and half an hour later, a new electric furnace was in place to start smelting molten steel. One furnace is produced every half hour, and each furnace is 2 tons.
Once the production capacity is turned on, there is not enough fuel in a blink of an eye. Chu Jungui took the cart with him. The trees in the open area had been cut down, so he came to the edge of the forest and started sawing and processing the wood. This time he chose large trees with high density and hardness. Ten minutes later, Chu Jungui dragged the cart back to the base. Four logs were placed on the cart, weighing 15 tons. The reason why we don’t load more is because the pallet truck can only carry so much weight, and the ground cannot bear it.
After returning the wood to the camp, Chu Jungui immediately returned and started picking the next batch. This hour is spent cutting wood. The hour soon ended. Counting the time spent traveling back and forth, Chu Jungui's total production capacity was 60 tons of logs. The bottleneck of production capacity is mainly the pallet truck. Chu Jungui began to consider whether to build an eight-wheel wide-tire pallet truck or something. It couldn't be mounted on tracks, so how could he collect 200 tons of logs an hour.
However, 60 tons of logs are enough. 10 tons can be used for five thermal furnaces to burn for a whole day, and the rest are building materials.
At the fifth hour, Chu Jungui planned mining. With the 2-ton electric furnace in place, the mines were running out. Although the iron ore content in the real dream is extremely high, even with the current crude refining method, 4 tons of ore can produce 3 tons of iron, but as soon as the new electric furnace is fired, all the ore reserves that can be picked up nearby will be eaten up. net.
The mining cliff was one kilometer away. Chu Jungui added a protective plate around the cart, doubled the width of the wheels, and went to the mining cliff.
Regardless of the type of ore in the mining cliff, most of it exists in the form of slate. Chu Jungui parked the cart dozens of meters away, picked up the special mining pick, took long strides and started to run, then jumped up, and his body gradually rose until it was level with a dark red mineral belt ten meters high. , the mining pick brought out an arc light and dug hard into the mineral zone, almost the entire front edge was not penetrated into the rock!
Chu Jungui pushed hard on the cliff and used his strength to pry. With a crash, a large piece of mineral rock fell away from the mountain wall, and then broke into more than a dozen pieces on the ground.
The large piece of ore pried off is seven to eight meters square and more than half a meter thick. Chu Jungui landed lightly on the ground, then picked up a one-meter-square piece of ore and weighed it. This piece of ore is about half a cubic meter, but weighs 4 tons. Its density is already higher than that of real iron. However, in real dreams, one cubic meter of iron weighs 9 tons.
Chu Jungui only put three pieces of ore on the cart, which already weighed more than 20 tons. The ore he pried off was more than 200 tons, and it seemed that he had to move it at least 10 times.
Moving back and forth was much faster. In less than an hour, Chu Jungui mined twice and moved back and forth nearly 20 times, with a cumulative production capacity of 400 tons. These mines were enough for the time being, and Chu Jungui finally felt a little tired, so he took the pot containing 180,000 calories and counted the data while eating.
The camp has only been under construction for 6 hours now and is already beginning to take shape. This production capacity should be much higher than that of a primitive village with a population of more than 100 people. Especially for metals, one furnace of Chujungui is their output in three years.
Looking at these data, Chu Jungui suddenly had a strange feeling, as if... he just called mass production?
Although there was some success, it was still far from the real mass production that Chu Jungui had in mind, and these supplies were far from enough to fight against that monster and its alienated warriors who were at least a few hundred sizes older.
Chu Jungui finished most of the pot of dark food in three mouthfuls, then rubbed a bunch of grass roots, leaves and berries into it, replenished the pot, and started the next project.
At the seventh hour, Chu Jungui built a smelting furnace. This is not the primitive electric furnace, but a smelting furnace from the interstellar era, just like the one he built on Planet 4. The production capacity and efficiency of the smelting furnace are much higher than that of the electric furnace, and the key to building it is actually the micro-master brain. But wherever a micro master brain is needed, Kaitian can solve it. It worked hard for several hours and was able to control a few more devices.
This smelting furnace smelts limestone, river mud, river sand and other materials, and what comes out are non-metallic building materials, similar to the concrete of the home planet era. This production capacity is very fast, one furnace takes 10 minutes, and a single furnace is 2 cubic meters, which means 12 cubic meters of concrete can be produced in one hour.
At the eighth hour, the second smelting furnace was put in place, the manufacturing machine began to produce steel plates and fasteners, and Chu Jungui began to lay the foundation for the camp.
At the 9th hour, defense construction officially began.
Chu Jungui first built a 10-meter baseline wall on the side facing the forest, erected ten thin steel plates of one square meter each and 1 centimeter thick, and then erected a 30-centimeter-thick hardwood board outside, leaving a 40-meter gap between the two boards. cm gap, pour concrete in the middle, and finally fix it with strong pieces.
The performance of non-metallic building materials is much better than that of old-fashioned concrete. It only takes 10 minutes to harden. If Chu Jungui uses heat to bake it, it can be shortened by half.
15 minutes later, Chu Jungui built another layer, and finally it became an outer wall 10 meters long and 2 meters high. Chu Jungui estimated that even a 12.7mm caliber armor-piercing bullet could not penetrate this wall, but from the outside, it looked like an ordinary wooden wall.
At the end of the 10th hour, Chu Jungui built three defensive outer walls and built a low platform of less than one meter inside. In this way, when a person stands on it, most of his upper body is exposed outside the wall, which is convenient. shooting.
When building defense facilities, Kaitian controlled the manufacturing machine non-stop, half of which made alloy arrows, and the other half of which made steel plates and other various components.
The alloy arrows exported by the manufacturing machine are of uniform quality and have the same center of gravity. The heavy arrows are 500g and the light arrows are 150g. There are 5 in a single batch and 10 batches can be produced per hour. Therefore, by the end of the 10th hour, Chu Jungui already had 250 alloy arrows. .
While he was busy, Kaitian suddenly issued a warning: "Master, switch to shortwave vision!"
"Um?"
Chu Jungui's pupils changed, and he looked towards the forest, and then he saw vague figures moving quickly, running towards him quickly. Judging from the outline, it is the ape monster that Chu Jungui once encountered, but there are three obviously tall figures among them. Normal human vision cannot see them, but they are at the far end of the ultraviolet zone and close to the X-band area. , they are extremely eye-catching.
There were more than 200 ordinary ape monsters attacking. A few hours ago, they might have caused Chu Jungui some trouble, but now, two and a half boxes of alloy arrows were placed at Chu Jungui's feet.
Although the power of the alloy arrows is enough to kill the ape monster instantly, and it does not rule out the possibility of piercing two or three, the experimental subject who has always been cautious still feels a little lack of confidence. After all, he is not a god, and there will always be one or two arrows that miss. There are times when the adventurous arrows are not enough.
(End of chapter)
